Operating Instructions - ViewSonic E96f+SB-1 Service Manual

OPERATING INSTRUCTIONS

This procedure gives you instructions for installing and using the Color display.
1. Position the display on the desired operation and plug the power cord into a convenient AC outlet. Three-wire
power cord must be shielded and is provided as a safety precaution as it connects the chassis and cabinet to the
electrical conduit ground. If the AC outlet in your location does not have provisions for the grounded type plug,
the installer should attach the proper adapter to ensure a safe ground potential.
2. Connect the 15-pin color display shielded signal cable to your signal system device and lock both screws on the
connector to ensure firm grounding. The connector information is as follow:
PIN NO.
1.
2.
3.
4.
5.
6.
7.
8.
3. Apply power to the display by turning the power switch to the "ON" position and allow about thirty seconds for
display tube warm-up. The Power-On indicator lights when the display is on.
4. With proper signals feed to the display, a pattern or data should appear on the screen, adjust the brightness and
contrast to the most pleasing display.
5. This monitor has power saving function following the VESA DPMS. Be sure to connect the signal cable to the PC.
6. If your color display requires service, it must be returned with the power cord.
ViewSonic Corporation
1
6
11
15 - Pin Color Display Signal Cable
DESCRIPTION
RED-V
GREEN-V
BLUE-V
NC
GND
GND-R
GND-G
GND-B
5
5
10
15
PIN NO. DESCRIPTION
9. 5V From PC
10. Sync GND
11. NC
12. SDA
13. H- SYNC
14. V- SYNC
15. SCL
Confidential - Do Not Copy E96f+SB-1