Sony TC- WE675 Operating Instructions Manual page 8

- Multi-AMS/Auto
Play/Memory Play
You can locate the following/previous tracks
within a range of 30 tracks (Multi-AMS:
Automatic Music Sensor) or the beginning of a
tape quickly (Auto Play). You can even locate
a specific point anywhere on a tape (Memory
Play).
Note
Check the direction indicator of the deck you use.
When you locate a track on the reverse side (when
4 lights up), press the button(s) in the parentheses.
To locate
Press
The beginning of the
next or succeeding
tracks (Multi-AMS)
bb (or 44) as many
times as you want during
playback.
For examole. to locate 2
tracks ahead, press twice.
The beginning of the + (or w) once during
current track
(Multi-AM9
playback.
The beginning of the
44 (or w) as many
preceding tracks
times as you want during
(Multi-AMS)
playback.
The beginning of a tape
(Auto Play)
For example, to locate 2
tracks behind, press three
times.
MEMORY repeatedly until
"M" disappeais in the
display. Then press 44
(or H) while holding
down D (or U).
A particular point on a
MEMORY repeatedly until
tape (Memory Play)
"M" appears in the display.
Find the point you want,
then press RESET to reset
the tape counter and to
memorize the point.
To locate the memorized
point and start playback,
press + (or w) while
holding down D (or U).
(Press 44 or W to stop at
"0000". 1
Notes
* The MultiLAMS function may not work correctly if:
-the blank space between tracks is less than 4
seconds long.
- there is a passage of low frequencies or very low
volume within a track.
- the signal strength of the left and right channels
are very different.
l
The MultiLAMS function is inoperative on a deck
whenever the other deck is playing, recording
(except during dubbing), or in pause.
* Even if DIRECTION MODE is set to a, the
deck stops when the current side reaches the end
during MultiCAMS operation.
* The tape counters are reset to "0000" when you turn
off the tape deck.
- RMS Play
(TGWE675 only)
By creating a program, you can play back
tracks on deck A in any order
that you want.
The Random Music Sensor (RMS) function lets
you create a program
of up to 28 tracks, from
the 1 st to the 14th tracks on each side of the
tape.
1 Press RMSISTART.
"RMS" and a flashing cursor appear in the
display.
2 Press U (BACK) or D (FRONT) to
select the side of the tape.
Q or
D
appears in the display.
3 Press 44 or H repeatedly until the
track number you want appears in the
display.
I
Side of the cassette
Track number
8