Sony TC- WE675 Operating Instructions Manual page 18

Using the CONTROL All/ control
Synchro-recording with a CD
system (continued)
player
Connecting the CONTROL
Al II control system
Connect monaural (2P) mini-plug cables in
series to the CONTROL Al11 jacks on the back
of each component. You can connect up to ten
CONTROL Al11 compatible components in
any order. However, you can connect only one
of each type of component (i.e., 1 CD player, 1
MD deck, 1 tape deck and 1 receiver). (You
may be able to connect more than one CD
player or MD deck, depending on the model.
Refer to the operating instructions supplied
with the respective component for details.)
By pressing SYNCHRO, you can perform
synchro-recording on your tape deck with a
Sony CD player connected to the CONTROL
A 1 II connector through a CONTROL A 1 II
cable.
1 Set the source selector on the amplifier
to CD player.
2 Load a CD into the CD player.
3 Select the play mode (CONTINUE,
SHUFFLE, or PROGRAM) of the CD
player.
Example
Amplifier
(Receiver)
CD player MD deck
4 Load a cassette into deck B.
5 Select the side(s) to be recorded on.
To record on Set DIRECTION MODE to
Only
one side =
Both
side
0 or RELAY
6
Select the side you want to start
recording from on deck B.
To record from Press
Tape deck Other component
In the CONTROL Al11 control system, the
control signals flow both ways, so there is no
distinction of IN
and
OUT jacks. If a
component has more than one CONTROL A 1 II
jack, you can use either one, or connect
different components to each jack.
The front side D
The reverse side 4
7
Press SYNCHRO.
To stop CD Synchro-recording
Press w on deck B or the CD player.
About the connecting cable
When a CONTROL Al11 compatible
component is not supplied with a connecting
cable, use a commercially available monaural
(2P) mini-plug
cable
less than 2 meters (6.6
feet) long, with no resistance (such as the Sony
RK-G69HG).
18