Advertisement
Quick Links
DISHWASHER
EN
EN
Positioning and levelling
Connecting the water and electricity supplies
Technical data
Overall view
Control panel
Lower rack
Cutlery basket
Upper rack
Starting the dishwasher
Loading the detergent
Washing options
Wash cycle table
Loading the rinse aid
Loading the refined salt
Shutting off the water and electricity supplies
Cleaning the dishwasher
Preventing unpleasant odours
Cleaning the sprayer arms
Cleaning the filters
Leaving the machine unused for extended periods
General safety
Disposal
Saving energy and respecting the environment
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Indesit IDTM
Summary of Contents for Indesit IDTM
- Page 1 Connecting the water and electricity supplies Technical data Overall view Control panel Lower rack Cutlery basket Upper rack Starting the dishwasher Loading the detergent Washing options Wash cycle table Loading the rinse aid Loading the refined salt Shutting off the water and electricity supplies...
- Page 2 If it has been damaged, contact the retailer and do not proceed any further with the installation process. 2. Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent cabinets or even with the wall. This appliance can also be recessed under a single worktop ( see the Assembly instruction sheet ).
- Page 3 30 KPa ÷ 1 MPa (0,3 ÷ 10 bar) 4,3 psi-145 psi See appliance data plate See appliance data plate See appliance data plate This dishwasher conforms to the following European Community Directives: -73/23/EEC dated 19/02/73 (Low Voltage) and subsequent modifications...
- Page 4 - Live Live Live Live Live Caution: Caution: The dishwasher plug must be accessible Caution: Caution: Caution: even when the appliance is installed as a built-in unit so that maintenance can be done safely. As the colours of the wires in the mains lead may...
- Page 5 indicator indicator lights light* indicator light indicator light button* Upper rack Upper sprayer arm Tip-up compartments Rack height adjuster Lower rack Lower sprayer arm Cutlery basket Washing filter Salt dispenser Detergent and rinse aid dispensers Data plate indicator light* button indicator light* * Only available in selected models.
- Page 6 Stemmed glasses can be hooked on by threading the stems into the slits. Items that should not be washed in the dishwasher • Wooden items, objects with wooden or horn handles or glued-on parts.
- Page 7 AUTO4YOU programme. It is important to remember that: • if the 3h cycle has been selected the dishwasher will wail for 30 minutes and then wash for the remaining 150 minutes • if the 6h cycle has been selected the dishwasher will wail for...
- Page 8 INDESIT dishwashers are equipped with an automatic filter cleaning system so that they do not become clogged with food residues. This function may extend the duration of the wash cycles. If there is a high level of dirt contained in the filters, the dishwasher will stop operating (see Troubleshooting - Blocked filter alarm) .
- Page 9 Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher ( see Description ) and should be filled: • when the green float* cannot be seen by simply looking at the cap of the salt dispenser;...
- Page 10 3. Reconstruct the filter assembly and replace it in the correct position, following movements 1 and 2 as shown in the figure, until it clicks into place. • Run a wash cycle when the dishwasher is empty. • Unplug the appliance and disconnect the water supply.
- Page 11 Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. • Only start a wash cycle when the dishwasher is full. While waiting for the dishwasher to be filled, prevent unpleasant odours with the Soak cycle ( see Wash Cycles ).
- Page 12 • Switch off the machine by pressing the ON/OFF button and clean the filters (see Maintenance), then switch the dishwasher back on by pressing the same button. Re-programme the machine and restart the wash cycle.
Need help?
Do you have a question about the IDTM and is the answer not in the manual?
Questions and answers