Peavey KB2 Owner's Manual page 6

Keyboard amplifier

Hide thumbs Also See for KB2:

R R E E A A R R P P A A N N E E L L

M M a a i i n n L L i i n n e e O O u u t t ( ( 9 9 ) )

This low-noise‚ electronically-balanced XLR connector can be used to route signals to a mixing

console‚ recording device‚ etc.

S S e e n n d d / / R R e e t t u u r r n n J J a a c c k k s s M M a a i i n n s s ( ( 1 1 0 0 & & 1 1 1 1 ) )

This pair of 1/4" jacks allow the use of various auxiliary units (effects units‚ equalizers‚ etc.) in-line‚

before the power amp section.

H H e e a a d d p p h h o o n n e e J J a a c c k k ( ( 1 1 2 2 ) )

This 1/4" jack accepts stereo headphones only.

C C H H 4 4 / / M M o o n n i i t t o o r r I I n n p p u u t t J J a a c c k k ( ( 1 1 3 3 ) )

Use this 1/4" jack to connect to the output of any line-level device.

C C h h a a n n n n e e l l : : 3 3 L L o o w w - - I I m m p p e e d d a a n n c c e e I I n n p p u u t t ( ( 1 1 4 4 ) )

For use with low-impedance microphones or other line-level sources equipped with a male XLR

connector.

C C h h a a n n n n e e l l s s 3 3 ‚ ‚ 2 2 & & 1 1 ( ( 1 1 5 5 ) )

These 1/4" jacks accept high-impedance microphones or line-level sources equipped with

⁄

" phone plugs.

E E x x t t e e r r n n a a l l S S p p e e a a k k e e r r J J a a c c k k ( ( 1 1 6 6 ) ) ( ( K K B B 3 3 o o n n l l y y ) )

This 1/4" jack provides the powered signal from the amplifier. Use this jack to add a second speaker

cabinet in parallel. The external minimum speaker load impedance is 8 ohms.

I I E E C C c c o o n n n n e e c c t t o o r r / / d d e e t t a a c c h h a a b b l l e e l l i i n n e e c c o o r r d d ( ( 1 1 7 7 ) )

This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings

for the intended operating voltage is included in the carton. The mains cord should be connected to

the amplifier before connecting to a suitable AC outlet.

U U . . S S . . D D o o m m e e s s t t i i c c A A C C M M a a i i n n s s C C o o r r d d

The mains cord supplied with the unit is heavy-duty‚ 3-conductor type with a conventional 120 VAC

plug with ground pin. Never break off the ground pin on any equipment. It is provided for your safety.

If the outlet used does not have a ground pin‚ a suitable grounding adapter should be used and the

third wire should be properly grounded.

Kb3