Safety note CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT SPLIT COVER(OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with the arrowhead symbol, within an equilateral triangle is intended to alert the user about the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
• A defective or soiled disc inserted into unit can cause sound to drop out during playback. • Handle the disc by holding its inner and outer edges. • Do not touch the surface of the unlabeled side of the disc. Do not stick paper or tape etc.
Battery Installation 1 Pull out the battery holder with a sharp product like a ball point pen. 2 Put the battery with correctly on the battery holder. 3 Push the battery holder back into its original position. Note • Use only one CR2025 (3V) lithium battery. •...
Connection diagram Before connecting, make sure that the ignition switch is set to OFF, and remove the battery # terminal to avoid short circuits. To Speaker To Vehicle (Optional) (Optional) PHONE MUTE (ORANGE) GROUND(-) (BLACK) DIMMER (PINK) DIMMER SWITCH TO IGNITION (RED) IGNITION SWITCH TO BATTERY(+) (YELLOW) POWER ANTENNA (BLUE)
From antenna To the wiring of the vehicle colors of leads. • BLACK: This lead is for the ground connection. • ORANGE: This lead is for the phone line connection. • PINK: This lead is for the dimmer line connection. •...
Basic operation Turning the unit on Press PWR (POWER on the remote control) or any other button. Note When you insert the CD in the CD slot, the unit turns on. Turning the unit off Press PWR (or press and hold POWER on the remote control).
BEEP 2ND / ALL Sets the beep sound every time a button is pressed. BEEP 2ND The beep is generated when a key is long pressed. (1 sec) BEEP ALL The beep is generated when any key is pressed. Using the EQ (Equalizer) - * Optional Press EQ repeatedly.
XDSS+ (Extreme Dynamic Sound System) 1 Press XDSS XDSS+ : Improves the treble, bass sound. 2 To cancel, press XDSS again. Setting the clock 1 Press the DISP (CLOCK) and then, press and hold DISP (CLOCK) for more 1 second. 2 Press the M?+ to adjust the hour.
To scan the preset stations Press AS/PS. Each preset station appears. To cancel, press AS/PS. To tune in the preset stations Press BAND to select the desired band and press the desired preset button 1-6 (preset button 1-6 on the remote control). The preset station of the preset button 1-6 is displayed and the preset station is received.
Repeat The current selected tracks/files (1 RPT) or folder ( RPT) on the disc is played repeatedly. 1 Press RPT during playback. – 1 RPT appears on the display window. 2 Press and hold RPT for about 2 seconds during playback. –...
Troubleshooting : Symptom / : Cause The loaded disc is of a type this unit : Correction cannot play. Check what type the disc. Power doesn’t turn on. / The unit doesn’t operate. No sound is heard. / The volume Leads and connectors are not properly level will not rise.