DeLonghi DE60EPS Use And Care Instructions Manual page 40

Multi-function electronic oven installation and service instructions
Table of Contents

Advertisement

STAINLESS STEEL AND ALUMINIUM PARTS AND SILK-
SCREEN PRINTED SURFACES
Clean using an appropriate product. Always dry thoroughly.
IMPORTANT: these parts must be cleaned very carefully to avoid scratching and
abrasion. You are advised to use a soft cloth and neutral soap.
INSIDE OF OVEN
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm water.
Suitable proprietary chemical cleaners may be used after first consulting with the
manufacturers recommendations and testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/cloths should not be used on the cav-
ity surface.
NOTE: The manufacturers of this appliance will accept no responsibility for dam-
age caused by chemical or abrasive cleaning.
Do not store flammable material in the oven.
GRILL HEATING ELEMENT
The heating element is self-cleaning and does not require maintenance. The grill
is secured to the rear wall of the oven on a hinge system that allows it to be
lowered to allow proper access when cleaning the oven ceiling (
GREASE FILTER
Clean the filter after any cooking! The grease filter can be removed for cleaning
and should be washed regularly in hot soapy water (
Always dry the filter properly before fitting it back into the oven.
ADVICE FOR USE AND MAINTENANCE OF CATALYTIC PANELS
The catalytic panels are covered with special microporous enamel which absorbs
and does away with oil and fat splashes during normal baking over 200 °C.
If, after cooking very fatty foods, the panels remain dirty, operate the oven "idling"
on max temperature for about 30 minutes.
These panels do not require to be cleaned, however it is advised to periodically
remove them from the oven and to wash them with tepid soapy water and then
wipe off with a soft cloth.
DO NOT CLEAN OR WASH THEM WITH ABRASIVE PRODUCTS OR WITH
PRODUCTS CONTAINING ACIDS OR ALKALIS.
The side panels are reversible and when the catalytic microporous enamel degrades,
they can be turned to the other side.
40
Fig. 2.6 at page 14
Fig. 2.3
at page
13
).
).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents