Routing - Verizon VERSALINK 327W User Manual

VersaLink Wireless Gateway (Model 327W)

15.13 Routing

In the Advanced screen, click Routing. The Routing table maintains the routes or paths of where specific types of
data shall be routed across a network.
To add a new static route in the Router, click New Route.
IP Interfaces
Destination
Gateway
Netmask
Metric
RIP
Type
030-300505 Rev. A
Routing
The list of active interfaces on the Router and their IP and Subnet mask address.
eth0 is the local LAN interface.
lo0 is the loopback interface.
mainPPP is the WAN interface
The IP address or subnet of the Route.
Indicates were to send the packet if it matches this route.
If the Route is a Network route, Subnet Mask is used to specify the subnet address.
If the Route is a Host route, then the Host Route check box should be selected.
The RIP metric to be assigned to this route if and when it is advertised using RIP.
Indicates whether a static route should be advertised via RIP.
Indicates the type of route: Network route or Host route.
137
User Guide
April 2007