Outdoor Fan; Electrical Controls And Wiring; Burner Rack Removed; Removal Of Motor And Blower Wheel - Carrier Performance 48VL-A Installation Instructions Manual

Compressor
Access Panel
Fig. 19 - - Unit Access Panels
Fig. 20 - - Removal of Motor and Blower Wheel

Outdoor Fan

Control
Access
Blower
Panel
Access
Panel
A09211
BLOWER
HOUSING
2 SETSCREWS
(HIDDEN)

Electrical Controls and Wiring

Inspect and check the electrical controls and wiring annually. Be
sure to turn off the electrical power to the unit.
Remove access panels (see Fig. 19) to locate all the electrical
C99085
controls and wiring. Check all electrical connections for tightness.
Tighten all screw connections. If any smoky or burned connections
are noticed, disassemble the connection, clean all the parts, re- -strip
the wire end and reassemble the connection properly and securely.
After inspecting the electrical controls and wiring, replace all the
panels. Start the unit, and observe at least one complete cooling
cycle to ensure proper operation. If discrepancies are observed in
operating cycle, or if a suspected malfunction has occurred, check
each
instrumentation. Refer to the unit wiring label when making these
checks.
50
Fig. 21 - - Burner Rack Removed
CAUTION
!
UNIT OPERATION HAZARD
Failure to follow this caution may result in damage to unit
components.
Keep the condenser fan free from all obstructions to ensure
proper cooling operation. Never place articles on top of the
unit.
1. Remove 6 screws holding outdoor grille and motor to top
cover.
2. Turn motor/grille assembly upside down on top cover to
expose fan blade.
3. Inspect the fan blades for cracks or bends.
4. If fan needs to be removed, loosen setscrew and slide fan off
motor shaft.
5. When replacing fan blade, position blade as shown in Fig.
22.
6. Ensure that setscrew engages the flat area on the motor shaft
when tightening.
7. Replace grille.
electrical component with
A07680
the proper electrical