Table of Contents
Advertisement
Onboard FDC
Controller
Onboard Serial
Port 1 / Port2
UART 2 Mode This item allows you to select which mode for the
IR Function Duplex This item allows you to select the IR half / full duplex
TX, RX inverting
enabld
Onboard Parallel Port This item allows you to determine onboard parallel
Parallel Port Mode Select an operating mode for the onboard parallel
ECP Mode Use DMA Select a DMA channel for the parallel port for use
Select Enabled if your system has a floppy drive con-
troller (FDC) installed on the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Select an address and corresponding interrupt for the
first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
Onboard Serial Port 2.
The choice: Standard, HPSIR, ASKIR
function.
The choice: Half, Full.
This item allows you to enable the TX, RX inverting
which depends on different H/W requirement. This
field is not recommended to change its default set-
ting for avoiding any error in your system.
The choice: "No, No", "No, Yes"(default), "Yes, No",
"Yes, Yes".
port controller I/O address setting.
The choice: 378H/IRQ7, 278H/IRQ5, 3BC/IRQ7,
Disabled.
(printer) port. Select Normal, Compatible, or SPP
unless you are certain your hardware and software
both support one of the other available modes.
The choice: SPP, EPP, ECP, ECP + EPP.
during ECP mode.
The choice: 3, 1.
MAGIC-PRO MP-7VIP-A
49
Advertisement
Table of Contents
