Front View; Side View - Broan HRV100H Installer Manual

7. I
NSTALLATION OF THE
7.1 D
IMENSIONS AND
D , DH100W, VT1W,
EHUMIDISTAT
VT2W
AND
V : 12 volts DC
OLTAGE
5" (127 mm)
VC0016A

FRONT VIEW

7.2 I
NSTALLATION OF THE
Always disconnect the unit before making any connections. Failure in disconnecting power could result in electric
shock or damage of the control or electronic module inside the unit.
Failure to comply with the following can cause erratic operation of the unit:
• Never install more than one optional control per unit.
• Keep control low voltage wiring at least 1 foot (305 mm) away from motors, lighting ballast, light dimming circuit
and power distribution panel. Do not route control wiring alongside house power wiring.
• Ensure the wires are securely connected.
7.2.1 P M
LATINUM AIN
1. Route the cable from the unit to a convenient location for
the wall control.
2. Detach the front module
from the mounting plate by
pulling the bottom part.
3. Run the cable (4 wires)
through the central opening
of the mounting plate and
mount this plate to the wall
using screws (not included).
If needed, use wall anchors
(not included).
C
ONTROLS
S (M C
PECIFICATIONS AIN
1³/ "
8
(35 mm)

SIDE VIEW

M C
AIN ONTROL
C I
ONTROL NSTALLATION
VC0102
VC0103
)
ONTROLS
P
LATINUM
V : 12 volts DC
OLTAGE
4¼" (107 mm)
VC0105A
FRONT VIEW
!
WARNING
CAUTION
4. Splice back the end of the
cable to access the 4 wires.
Strip the end of each wire.
Connect each wire to its
corresponding terminal on
the back of the front module:
YELLOW wire to "Y" , RED
wire to "R" , GREEN wire to
"G" and BLACK wire to "B" .
Be careful not to pinch wires when reinstalling
the front module on its back plate.
5. Reinstall the front module over the back plate.
17
D -T
ECO OUCH
V : 12 volts DC
OLTAGE
1" 2¾" (70 mm)
(26 mm)
VC0118A
SIDE VIEW
RED
WIRE
GREEN
WIRE
VE0173
CAUTION
YELLOW
WIRE
BLACK
WIRE