Remote Control - Panasonic CS-S9KKQ Operating Instructions Manual

TO ENJOY CLEAN & FRESH AIR
8
PATROL
PATROL/
PATROL - To monitor air quality
• Detects air quality; e-ion operation
activates when air quality is at dirty
level.
• Regardless of air quality, to
maintain air freshness e-ion
activates automatically (PATROL
SENSOR indicator turns red) when:
- 2 minutes after the unit is on, or
- exceeds 4 hours at clean level.
• Can be activated even when the unit is turned off.
• Patrol starts automatically with the unit switched on with
OFF/ON
.
- To freshen and purify the air
• Generates negative ions to produce fresh air effect and
attract dust which will then be captured at the positively
charged e-ion fi lters.
• Can be activated even when the unit is turned off. In this
condition, fan speed and air swing can not be adjusted.
TO IMPROVE HUMIDITY AND MOISTURE LEVEL
9
• This operation reduces air dryness and provides you with
a comfortable living environment during COOL mode only.
• When vertical airfl ow direction is set to AUTO, it stops at
lower position to avoid cold air contact. However, you can
adjust the louver direction manually.
TO ENJOY QUIET OPERATION
10
• This operation reduces airfl ow noise.
TO REACH TEMPERATURE
11
QUICKLY
• This operation will stop automatically after 4 hours.
S18KKQ, S24KKQ, S28KKQ
NORMAL
Indicator Air Quality
Blue Clean
Orange Moderate
Red Dirty
6
Press and hold for 5 seconds to dim or restore the
12
unit's indicator brightness.
Press and hold for approximately 10 seconds to
13
show temperature setting in °C or °F.
Press to restore the remote control's default setting.
14
Not used in normal operations.
15
NOTES NOTES
PATROL/
QUIET POWERFUL
, ,
• Can be activated in all modes and can be cancelled
by pressing the respective button again.
ECO
QUIET POWERFUL
PATROL
, ,
• Cannot be selected at the same time.
• Cannot be activated during "MIILD DRY COOLING"
operation is activated.
TO SET THE TIMER TO SET THE TIMER
• 2 sets of ON and OFF timers are available to turn ON
or OFF the unit at different preset time.
• Complete below procedures to set each timer:
ON
Cancel
1
Cancel
OFF
Select ON or OFF timer
• Example of application at living room:
Morning: ON at 07:00 (Wake up)
OFF at 08:00 (Out for work)
Evening: ON at 17:00 (Back home)
OFF at 22:00 (Sleep)
• To cancel ON or OFF timer, press
select respective or
• If timer is cancelled manually or due to power failure,
you can restore the timer again by pressing
to select respective
OFF
• Upcoming timer will be displayed and will be activated
in sequence.
• When ON Timer is set, the unit may start earlier (up
to 15 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation at
back cover.
ECO
PATROL
,
2
SET
Set the
Confi rm
time
ON
or to
OFF
then press .
CANCEL
ON
or
SET
or then press .
5