Summary of Contents for SBI AC01336
- Page 1 PEDESTAL WOOD STOVE FRESH AIR ADAPTER KIT AC01336 INSTALLATION INSTRUCTIONS Stove Builder International inc. 250, rue de Copenhague Saint-Augustin-de-Desmaures Quebec, Canada G3A 2H3 45619A Printed in Canada 28-08-2012...
- Page 2 This pedestal wood stove fresh air adapter kit contains the following parts: 5" (127 mm) ADAPTER. BLACK METAL SCREW #10 X 1/2" TYPE "A" PAN QUADREX 5" (127 mm) INTAKE CAP COLLAR (4.93" TO 5.75")
- Page 3 Other required parts (not included): FLEXIBLE INSULATED FRESH AIR INTAKE SCREWS FOR INTAKE CAP PIPE (4' LENGTH / 5'' DIAMETER) AC02090 Tools required for installation: POWERED DRIVER CUTTING PLIERS Note: 5” flexible insulated pipe is not included because the length of pipe needed may vary from an installation to another.
-
Page 4: Installation
Installation When combustion air is taken from outside, you can bring it directly to the pedestal or near the unit. In the second configuration we recommend that the distance between the air intake and the pedestal does not exceed 5' (1.52 m). Here are two typical methods to bring fresh air into the unit. - Page 5 A) Installation of a fresh air intake from the wall to the back of the pedestal Step 1: Using cutting pliers, remove the micro-jointed air intake plate from the rear of the pedestal. Step 2: Using a powered driver, secure the air intake adapter (B) to the rear of the pedestal with 4 screws (C)
- Page 6 Step 3: Make a 6'' x 6'' (152 mm x 152 mm) opening in the exterior wall behind your stove. Attach the 5'' flexible insulated pipe (E) to the fresh air adapter flange with a collar (D). Attach the other end of the pipe (E) to the intake cap (F) located outside with a collar (D).
- Page 7 B) Installation of a fresh air intake from the floor to the base of the pedestal Step 1: Determine the final location of the stove and mark the dimension of the pedestal on the floor with tape. Move the stove and perform an opening of 5 1/2 "x 5 1/2" (140 mm x 140 mm) centered in the floor under the stove.
- Page 8 Step 2: Reinstall the stove over the opening. Step 3: Attach the other end of the insulated flexible pipe (D) to the intake cap (E) with a collar (C). Attach the intake cap (E) to the exterior wall using 4 screws (F) not provided in this kit.