Measurements And Adjustments; Introduction; Before Disassembling The Unit - Panasonic Lumix DMC-FT20EB Service Manual

Table of Contents

10 Measurements and Adjustments

When servicing this unit, make sure to perform the adjustments necessary based on the part(s) replaced.

Before disassembling the unit, it is recommended to back up the camera data stored in flash-rom as a data file.

IMPORTANT NOTICE (After replacing the Main P.C.B.)

After replacing the Main P.C.B., it is necessary to use the "DIAS" software to allow the release of adjustment flag(s).

The Adjustment software "DIAS" is available at "TSN Website". To download, click on "Support Information from NWBG/VDBG-

AVC".

*DIAS (DSC Integrated Assist Software)

10.2.1. Initial Setting Release

The cameras specification are initially set in accordance with model suffix (such as EB, EG, GC, and so on.).

Unless the initial setting is not released, an automatic alignment software in the camera is not able to be executed when the

alignment is carried out.

Note:

The initial setting should be again done after completing the alignment. Otherwise, the camera may not work properly.

Therefore as a warning, the camera display a warning symbol " ! " on the LCD monitor every time the camera is turned off.

Refer to the procedure described in "3.6.2. INITIAL SETTINGS" for details.

[How to Release the camera initial setting]

Preparation:

Attach the Battery to the unit.

Set to Normal picture mode by operating the mode button.

Step 1. Temporary cancellation of "INITIAL SETTINGS":

While pressing the UP of Cursor button and MOTION PICTURE button simultaneously, turn the Power on.

Step 2. Cancellation of "INITIAL SETTINGS":

Press the PLAYBACK switch.

While pressing UP of Cursor button and MOTION PICTURE button simultaneously, turn the Power off. (The warning symbol " ! " is

displayed on the LCD monitor.)

Table of Contents