Leaf Blower Vac
WARNING SYMBOLS
Some of the following symbols may be used on your
Leaf Blower Vac. Please look at them and understand
their meaning. Correct interpretation of these symbols
will allow you to operate the tool safely.
Symbol Explanation
WARNING!
This warning symbol is displayed on the leaf
blower vac to remind you of the safety
precautions you should take when operating it.
WARNING!
This leaf blower vac should only be used by
those persons who have read and understood
all the safety and operating instruction
contained in the instruction manual. Be aware
of the safety of all persons in the work area at
all times.
WARNING!
Switch the leaf blower vac OFF and disconnect
from the mains supply before making
adjustments, cleaning blockages, or starting
any cleaning and maintenance procedures.
WARNING!
Keep other people out of the work area!
WARNING!
Do not use this leaf blower vac in the rain.
Avoid using it in damp conditions.
WARNING!
When using this leaf blower vac, always wear
protective glasses and ear protectors.
WARNING!
Read these safety and operating instructions in
this booklet and keep them in a safe place for
future reference.
WARNING!
Dangerous vacuum openings. Keep hands and
feet out of the openings while the machine is
running.
WARNING!
Rotating Fans. Keep hands and feet out of the
openings while the machine is running.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Please read carefully before use and retain for future reference.
9242
1 Upper tube
2 Screw cover
7 Wheels
8 Lower tube
9 Collection bag strap
10 Collection bag connector
11 Blower/vacuum
selector lever
ASSEMBLY
1. Insert the lower tube into the
upper tube. Align the screw hole in
the upper tube with the screw hole in
the lower tube whilst ensuring the convex
plate aligns with the slot on upper tube correctly.
2. Locate the long screw 50mm in screw hole on upper tube and tighten the screw securely.
3. Push the wheel bracket onto the end lower tube until it rests against the rib on the lower tube.
4. Locate the shorter screw 15mm in the screw hole on wheel bracket and tighten the screw securely.
Lower
Tube
Convex
plate
Slot
Upper
tube
3
Assembly direction
Rib
Lower tube
5. Connect the strap (9) onto the hook (13) on the housing.
6. Attach the push-on collection bag connector (10) to the outlet tube of the housing. Push the
collection bag clip onto the outlet so that it clicks into position.
7. Repeat step 6 to connect the strap to the hook on the underside of the housing. To remove the
collection bag, reverse the procedures shown in 5, 6 & 7. When removing the fitting from the outlet,
press the two buttons on either side of the plastic connector in, and pull to release.
5
8. Connect the latch (5) on the shoulder harness (3) to the strap hanger in main housing. Adjust the
shoulder harness to a comfortable position.
Instructions
3 Shoulder harness
4 Front handle
2
4
Wheel
bracket
Screw
Screw
hole
6
5 Latch
6 Trigger switch
12 Label location
13 Hook for
collection bag
14 Power cord & plug
15 Collection bag
Screw
hole
7
Need help?
Do you have a question about the 9242 and is the answer not in the manual?
Questions and answers