AEG SANTO Operating Instructions Manual page 23

Symptom
The temperature display
shows "¨".
The food is too warm.
Interior lighting does not
work.
Heavy build up of frost,
possibly also on the door
seal.
Water on the floor or on
storage shelves.
Temperature cannot be set
Possible Cause
The electronics in the
appliance have detected a
fault that prevents the
ACTUAL temperature being
measured.
Temperature is not proper-
ly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Light bulb is defective.
Door seal is not air tight
(possibly after reversing
the door).
Water drain hole is
blocked.
COOLMATIC or FROSTMAT-
IC functions switched on.
What to do if...
Remedy
The appliance will continue
to function using a backup
programme until your local
Customer Service engineer
has repaired the appliance.
Please look in the "Starting
up and Temperature regu-
lation" section.
Open the door only as long
as necessary.
Turn the temperature
regulator to a colder set-
ting temporarily.
Please look in the
"Installation location" section.
Please look in the "Changing
the light bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a
cool setting). At the same
time shape the warmed
door seal by hand such
that it sits correctly.
See the "Cleaning and
Care" section.
Switch off COOLMATIC or
FROSTMATIC manually, or
wait to set the tempera-
ture until the function has
reset automatically (refer
also to COOLMATIC/FROST-
MATIC section).
49