Page 1
Please keep this manual available for references. CA Spas would like to congratulate you on your purchase and we sincerely hope you enjoy your QCA Spa. SERIAL NUMBER __________________ 18 DIGIT SPA NUMBER ___________________ Technical Service Toll Free 866-998-0148 QCA Spa Q2000 10.08...
water temperatures are recommended for 1. READ FOLLOW extended use (exceeding 10-15 minutes) and INSTRUCTIONS. for young children. 2a. DANGER - To reduce the risk of injury, do b. Since excessive water temperatures have a high not permit children to use this product unless potential for causing fetal damage during the they are closely supervised.
Installation Instructions Spa Location The selection of a site for the installation of your spa is a very important Electrical-General decision and should be undertaken keeping several Prior to performing any service to the spa package, factors in mind. turn OFF ALL primary electric power at the main circuit breaker or disconnect panel.
YOUR • QCA • SPA • EQUIPMENT Q2000 Control Jets Control Initial Start Up When first powered up, your spa will automatically Press the Jets pad once to turn on the pump and heat and maintain 100° F or 38° C until you ozone generator (if installed).
Your Water Care Program Before adding chemicals to your spa, do a full water analysis with a test kit or ask your QCA Spa dealer to The air control knob is located next to the spa control conduct the water test for you.
2.0 - 4.0 calcification that will result in reduced water flow. In ppm. your QCA Spa, it is important to maintain a clean, unobstructed filtering system. This not only provides 2. Test pH levels and adjust if needed. If you are...
Short Time Periods (3-5 Days): Spa and Cabinet Maintenance Prior to leaving: Acrylic Finish - The acrylic finish on all QCA 1. Adjust the pH by following the instructions spas is impervious to most of the problems associated outlined in the water quality and maintenance with non-acrylic finished spas and requires very little section.
A spa should be kept at temperatures less then 104° F or 40° C for personal safety and health. To validate your warranty the enclosed warranty must be filled out and returned to QCA Spas, Inc. within 30 days from date of purchase.
Please Note: the spa owner may perform the following corrective actions. If the trouble cannot be corrected in the steps below, please refer to your QCA Dealer for service. (Improper servicing by an unauthorized serviceman or spa owner could result in damage that will not be covered by the warranty, or could cause serious injury.)
Page 11
To receive your FREE gift to help maintain your spa and to VALIDATE your spa warranty, return the PREPAID registration card below within the next THIRTY days. To immediately register your new spa; you may log onto our web site at qcaspas.com...
Need help?
Do you have a question about the ENJOY Q2000 and is the answer not in the manual?
Questions and answers