Page 1
ENJOY Your QCA Paradise/Majestic Series Spa ML 900 Panel OWNER’S MANUAL his owner’s manual is for YOU! It will show you how to operate and maintain your very own spa. We think it is important for you to take a few moments and get acquainted with your new spa operation.
Underwriters Laboratories. These instructions are very important considered safe for a healthy adult. Lower for your safety and QCA would like to encourage you water temperatures are recommended for to read and apply all instructions. Thank you! extended use (exceeding 10-15 minutes) and for young children.
WARNING - the use of alcohol, drugs, or medication can Electrical-General greatly increase the risk of fatal hyperthermia in hot tubs Prior to performing any service to the spa package and spas. turn OFF ALL primary electric power at the main circuit breaker or disconnect panel.
Paradise/Majestic Series Initial Start-up Majestic and Paradise have the same buttons, only difference is logo When your spa is first powered up, it will automatically heat and maintain 100°F until you change the set temperature. In the event of a power failure or during a manual shutdown, the spa will revert to the last set temperature, mode, and filter cycle before the loss of power once power is restored.
Page 6
the unit. If the light or LED unit is left on, it will automatically turn off after 4 hours. Standby Mode OPTIC Pressing “Warm” or “Cool” then “Jets 2” will turn Button is not used for this model. off all spa functions temporarily. This is helpful when changing a filter.
similarly except t\with the temperature thresholds determined by the switch and without a 4-minute delay in turnoff. See you dealer for details. Locking the Panel Clean-up Cycle Press “Time” Jets 1” then the “Warm” with in 3 seconds. When locked the PL indicator light will When the pump or blower is turned on by a button light.
persists, contact your dealer or service organization. Persistent low flow problems. (Occurs Follow action required for “HTR FLOW LOW FLOW on the third occurrence of the “HTR LOW” message. FLOW LOW” message.) Heater is shut Turn spa off then back on again to restore down, but other spa functions continue heating capability.
Page 9
Operating instructions for Ultra Wave Lounge™: To start your sequencer: Press on/off key to turn sequencer on. The system will then perform an indicator light test and open all valves. Pressing a second time will turn sequencer off. A built-in timer automatically turns sequencer off after 2 hours, unless manually deactivated first.
Control for Seats 1, 2, Wave-Max™ 3 & Directional Jet Seat Control Turbo Boost 5” Directional Aromatherapy Waterfall Wave-Max™ Seat (#5) & Ultra™ Wave Lounger (#4) These seats operate off Jets #2. The power can be diverted from Wave Max seat to Ultra Wave Lounge by rotating the diverter valve at the top of the Wave Max seat.
On position or clockwise for 95% shut-off. Your QCA Majestic™ Spa has a standard 12v light. The Spa light may be turned ON or OFF by pressing the Light button located on the spa side control.
5. To eliminate and prevent foaming, add a small Before adding chemicals to your spa, do a full amount of NON FOAM as needed. water analysis with a test kit or ask your QCA Spa dealer to conduct the water test for you. General Guidelines Step 1: Always have the circulation system •...
("Purchaser") after May 1, 1998. To validate this warranty, the Purchaser must complete the enclosed warranty registration card and mail it to QCA MAJESTIC™ within 30 days of deliver of the spa. RETURN OF THE OWNER REGISTRATION CARD IS A CONDITION OF WARRANTY COVERAGE.
To receive your FREE gift to help maintain your spa and to VALIDATE your spa warranty, return the PREPAID registration card below within the next thirty days. To immediately register your new spa; you may log onto our web site at qcaspas.com.
Need help?
Do you have a question about the Majestic Series and is the answer not in the manual?
Questions and answers