Replacement Of Light Bulbs - Hyundai Elantra Owner's Manual

G290B03E-AAT
Adjustment After Headlight Assembly
Replacement
1.18 in. (30mm) Vertical line
Horizontal line W
Cut-off line
L Ground
line
H
G290B01A-1
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using an
aiming screen as shown in the illustration. Turn
on the headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustration.
2. Dotted lines in the illustration show the center
of headlights.
xdflhma-6.p65 25
Specification:
"H"
Horizontal center line of headlights from
ground.
Low beam : 25.2 in. (639 mm)
High beam : 23.3 in. (619 mm)
"P"
"W"
Distance between each headlight center.
H Low beam : 44.2 in. (1124 mm)
High beam : 33.0 in. (840 mm)
"L"
Distance between the headlights and the
wall that the lights are tested against.
: 118 in. (3,000 mm).
DO-IT-YOURSELF MAINTENANCE

REPLACEMENT OF LIGHT BULBS

G260A03A-AAT
Before attempting to replace a headlight bulb, be
sure the switch is turned to the "OFF" position.
The next paragraph shows how to reach the
headlight bulbs so they may be changed. Be
sure to replace the burned-out bulb with one of
the same number and wattage rating.
!
CAUTION:
Keep the lamps out of contact with petro-
leum products, such as oil, gasoline, etc.
9/24/04, 9:42 AM
6
25