WinFast NF4K8AB User Manual page 27

S-ATA Connectors: SATA0, SATA1, SATA2, SATA3
The Serial ATA connectors are used to con-
n e c t t h e S e r i a l ATA d e v i c e s t o t h e
motherboard. These connectors support the
thin Serial ATA cables for primary storage
devices. The current Serial ATA interface al-
lows up to 150MB/s data transfer rate. Refer
to chapter 5 on how to set up SATA RAID con-
figurations for details.
Front Audio Connector: F_AUDIO
The audio port includes two parts – the Front
Audio and Rear Audio. Their priority is se-
quenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the
front panel of the chassis (using the Front
Audio), then the Line Out (Rear Audio) on the
rear panel will not work. If you do not want to
use the Front Audio, pin 5 and 6, pin 9 and 10
must be short, and then the signal will be
sent to the rear audio port.
Audio Connector: CD_IN
C D _ I N i s S o n y s t a n d a r d C D a u d i o
connectors, to receive audio input from the
CD-ROM, attach its audio connector to the
C D _ I N a u d i o c o n n e c t o r s o n t h e
motherboard.
Speaker Connector: SPEAKER
The speaker connector is used to connect
speaker of the chassis.
Chapter 2 Installation Instructions
NF4K8AB Series User Manual
GND
RX+
RX-
GND
TX-
TX+
GND
SATA0/1/2/3
1 2
MIC_IN
MIC_PWR
AUD_OUT_R
NC
AUD_OUT_L
9 10
F_AUDIO
CD_L
GND
CD_R
CD_IN
SPKJ
NC
EMPTY
SPK(Pull high)
1
SPEAKER
MIC_GND
+5VAC
AUD_RET_R
EMPTY
AUD_RET_L
19