Radio; Storing And Receiving Stations; Storing Automatically - Btm; Storing Manually - Sony CDX-GT930UI Operating Instructions Manual

1
Press
(ZAP)
during playback.
After "ZAPPIN" appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
Track
- - ~ -----rr=-__
---rr=--__--;
L.....---t------l
The part of each track to
playback in ZAPPIN mode.
2
Press the multi way encoder or
(ZAP)
when a track you want to listen is
played back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps I and 2.
Tips
• You can select the playback time from about 6
seconds/9 seconds/3D seconds (page 20). You
cannot select the passage of the track to playback.
• Push the multi way encoder left/right in ZAPPIN
mode to skip
a
track.
• Push the multi way encoder up/down in ZAPPIN
mode to skip album.
• Pressing
~
(BACK) also confirms
a
track to
playback.
Radio
Storing and receiving stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically - BTM
1
Press
(SOURCE)
repeatedly until
"TUNER" appears.
To change the band, press
(MODE)
repeatedly. You can select from FM I, FM2,
FM3, AMI or AM2.
2
Press and hold the multi way encoder.
3
Rotate the multi way encoder until
"B1M" appears, then press it.
The unit stores stations in order of frequency
in the preset list.
A beep sounds when the setting is stored.
Storing manually
1
While receiving the station that you
want to store, push
Q
(BROWSE)/CA1.
The preset list appears.
2
Rotate the multi way encoder to select
the preset number.
3
Push and hold the multi way encoder
until "MEM" appears.
(with the card remote commander)
1
While receiving the station that you
want to store, press and hold a
number button
(CD
to ®) until
"MEM" appears.
Note
If you try to store another station on the
same
number
button, the previously stored station will be replaced.
ReceiVing the stored stations
1
Select the band, then push the multi
way encoder up/down.
(with the card remote commander)
1
Select the band, then press a number
button
(CD
to
®).
-
13