Hitachi CR 13V Instruction Manual And Safety Instructions page 11

(2) Push the lever in the direction of the arrow mark
shown in Fig. 3 marked on the lever. (Fig. 3)
(3) Insert the saw blade all the way into the small
slit of the plunger tip with the lever pushing.
You can mount this blade either in the upward
or downward direction. (Fig. 4, Fig. 5)
Blade
Slit of
Plunger
(4) When you release the lever, the spring force will
return the lever to the correct position
automatically. (Fig. 6)
(5) Pull the back of the saw blade two or three times
by hand and check that the blade is securely
mounted. When pulling the blade, you will know
it is properly mounted if it clicks and the lever
moves slightly. (Fig. 7)
CAUTION:
When pulling the saw blade, be absolutely sure
to pull it from the back. Pulling other parts of
the blade will result in an injury.
7. Dismounting the blade
(1) Turn on and off the switching trigger several
times so that the lever can jump out of the front
cover completely. Thereafter, turn off the switch
and unplug the power cord. (Fig. 2)
CAUTION:
Be absolutely sure to keep the switch turned off and the power cord unplugged to
prevent any accident.
(2) After you have pushed the lever in the direction of the arrow mark shown in Fig. 3,
turn the blade so it faces downward. The blade should fall out by itself. If the blade
doesn't fall out, pull it out by hand.
Fig. 4
Lever
Fig. 3
Blade
Slit of Plunger
Fig. 5
Lever
Fig. 6
Blade
Lever
Fig. 7
English
11