Advertisement
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended two or more people assembling this
machine to avoid possible injury.
STEP 1
(See Diagram 1)
A.) Connect the Right Upright Beam (#3) to a Rear Stabilizer (#14). Secure them with one
Bent Bracket (#17), two M10x3 ¾" Carriage Bolts (#47), two
M10 Aircraft Nuts (#50). Repeat the same procedure to assemble the other side.
B.) Connect the two Upright Beams by a Cross Brace (#13) in the mid span. Secure them
with one Bent Bracket (#17), two M10 x 3 ¾" Carriage Bolts (#47), two
(#48), and two M10 Aircraft Nuts (#50) on each side.
C.) Insert two Crutches (#12) into the top openings on the top of Left & Right Upright Beams.
Insert two M12 Lock Knobs (#36) through selected holes to obtain desired height.
D.) Insert the Left and Right Safety Hooks (#20) & (#21) into the holes on top of the Crutches
(#12). Secure them with two M8 Aircraft Nuts (#51).
E.) Push four Ø 3" End Caps (#32) onto both ends of the two Rear Stabilizers.
5
¾" Washers (#48) and two
¾" Washers
Hide quick links:
Advertisement
