Battery Charging Procedure - Minelab F Series Operation Manual

F Series Battery Charger Operations Manual
Figure 4. F Series Battery Charger Front Panel
8.

Battery Charging Procedure

Warning: Do not attempt to recharge alkaline or carbon batteries. Use
only 4.5Ah NiCad batteries with the Charger.
Ensure that the Set-up procedure (Section 7) has been completed.
a. Remove either the two left or two right hand side battery retaining caps
from the Charger by rotating them one quarter turn anti-clockwise. Note
that a set of four batteries will not charge if two are placed in one right
side tube, and two in one left side tube.
different levels of charge.
charged batteries could result in damage to the batteries.
b. Insert four "D" cell rechargeable batteries into the battery tubes (two
batteries per tube) ensuring the '+' end of each battery faces to the front
of the Charger.
Discharging
Charging
Ready
Power
DISCHARGE
Mixing discharged batteries with partially
Discharging
Charging
Ready
Power
DISCHARGE
CAUTION
: Use only Minelab
specified rechargeable batteries.
Other types of batteries may burst
causing injury to persons and damage.
P0565-A
Never mix batteries with