Table of Contents
Advertisement
ASSEMBLY
G
Position detector upright.
1
G
Rotate the LOCKING COLLAR fully in the
2
counterclockwise direction.
G
Insert your finger inside the tube and make sure the
3
INTERNAL CAM LOCK is flush with the inside of the tube.
S-ROD
G
Insert the MIDDLE STEM into the
4
S-ROD, with the SILVER BUTTON
pointed upward
G
Rotate the MIDDLE STEM until the
5
SILVER BUTTON locates in the hole.
G
Twist the LOCKING COLLAR fully in the clockwise
6
direction until it locks.
G
Repeat this process on the LOWER STEM.
7
G
Using the BOLT and KNURLED KNOB, attach
8
the SEARCHCOIL to the LOWER STEM.
G
Adjust the LOWER STEM to a length that lets you
9
maintain a comfortable upright posture, with your arm
relaxed at your side, and the SEARCHCOIL parallel to the
ground in front of you.
G
Wind the CABLE securely around the STEMS.
1 0
G
Connect CABLE PLUG to housing.
11
Do not twist the Cable or Plug. Turn Locking Ring only. Use
minimal finger pressure to start the threads. Do not cross-
thread. When the Locking Ring is fully engaged over the
threaded connector, give it a firm turn to make sure that it
is very tight. When the Locking Ring is fully engaged over the
threaded connector, it may not cover all of the threads.
G
Tighten both LOCKING COLLARS.
1 2
Armrest Adjustment
If you wish to change the
position of the armrest, remove
the screw and move the armrest
to one of the alternate hole
locations.
*
Note: Very tall users can purchase the optional Extended Lower Stem (TUBE5X), for extended reach.
4
4
Caution:
Forcing in MIDDLE STEM with CAM LOCK raised may form a burr on
camlock. If this happens, remove burr with knife to allow insertion.
G
LOCKING
2
COLLAR
G
INTERNAL
3
CAM LOCK
SILVER BUTTON
G
MIDDLE
4
STEM
G
5
G
4
Battery
Compartment
(back side)
*
Biaxial
Searchcoil
Advertisement
Table of Contents
