Connecting the Camera to Your Computer and Saving Files
IMPORTANT!
• The camera does not support operation with Mac OS X 10.0. Operation is
supported with Mac OS 10.1, 10.2, 10.3, 10.4, 10.5, 10.6, 10.7 and 10.8 (using the
OS standard USB driver) only.
NOTE
• You also can use your computer's card slot (if it has one) or a commercially
available card reader to access image files directly from the camera's memory
card. For details, see the user documentation that comes with your computer.
. To connect the camera to your computer and save files
1.
Turn on the camera. Next, press [SET] and then display the REC menu
(page 55) or the PLAY menu (page 71).
2.
On the "Set Up" tab, select "USB" and then press [6].
3.
Use [8] and [2] to select "Mass Storage", and then press [SET].
4.
Turn off the camera and
then use the USB cable
that comes with the
camera to connect it to
your Macintosh.
• Connecting the camera to
a computer with a USB
cable starts charging of
the camera's battery
(page 17).
• Make sure that you insert
the cable connector into
the USB/AV port until you
feel it click securely into
place. Failure to insert the
connector fully can result
in poor communication or
malfunction.
USB port
Large connector
Making sure that the
connector is towards the lens side, connect the
cable to the camera.
91
USB cable
(included with camera)
[USB/AV] port
Small connector
mark on the USB cable
Using the Camera with a Computer