Table of Contents
Advertisement
3.4 Supervisor Menus
The Supervisor menus provides advanced options for the following features:
•
Disk Status.
•
Reset Disk Failure.
•
Serial Debug Output.
The Key Pad buttons provides access and control of the Supervisor Menus. To
access the Supervisor menus press the left and right arrows simultaneously.
•
Up Arrow: Quits the menu.
•
Left Arrow: Move field selection to left.
•
Enter Button: Press to access setup
menu. Toggles through menu screens.
•
Right Arrow: Move field selection to right.
•
Down Arrow: Quits the menu.
Disk Status
This menu indicates the current disk status.
Disk status is viewable only on this display.
•
N: Normal
•
W: Error writing to Disk
•
R: Error Reading Disk
•
T: Timeout during disk initialization or disk
absent
•
E: Fails Disk Test
The letters on the Disk Status screen represent Disk 1 (left) thru Disk 8 (right).
NOTE
Do not attempt to reset a disk with read/write errors (a R or W
status). This could lead to more disk errors and data loss. Disks
with read/write errors should be replaced.
NOTE
Disks with a T status may be recovered, but the DVSe will
attempt to start recording to this disk. A recovery should not be
attempted until the preceding disk is filled up. Contact Technical
Support for detailed instructions on replacing or recovering
problem hard disks.
DVSe
18
0150-0178H
Advertisement
Table of Contents
