Configuring The Hard Drives; Mounting The Hard Drives; Connecting The Hard Drives - GE Digital Video Storage System User Manual

2.4 Configuring the Hard Drives

Hard drives are connected in pairs
to each of the four IDE
connectors. Each pair of hard
drives must be configured as a
Master and a Slave. Configure
the Master/Slave settings on each
hard drive individually using the
jumpers provided with the drive.
Use the diagram located on the
hard drive to determine the proper
jumper configuration.

2.5 Mounting The Hard Drives

Remove the Hard Drive Support Bracket. This entails removing the screws at
either end and one screw from each installed hard drive.
Orient the hard drive so that the IDE Power Connector is near the bottom of the
chassis and facing the motherboard. Populate the drive array in order, starting
from the left.
Fasten the drive in place using the supplied screws. Fasten each drive using two
screws through the bottom of the chassis and one screw in the Hard Drive
Support Bracket.

2.6 Connecting the Hard Drives

Power Supply Cables
It is recommended, for ease of installation, that the IDE and power
NOTE
cables be first connected to the drives before the drive screws are
tightened.
DVSe 12 0150-0178H