Subscribe to Our Youtube Channel
Related Manuals for Harbinger HA1000
Summary of Contents for Harbinger HA1000
- Page 1 ® OWNER’S MANUAL HA1000 POWERED MIXER 2 X 500 BUILT IN WATTS INPUTS www.harbingerproaudio.com...
-
Page 2: Welcome
It’s packed with quality features usually found only on larger, • 2 x 500W output power with Stereo, Main/Monitor, or Bridge more expensive systems. To get the most from your new HA1000, Mono operation take a moment and read through this entire manual to learn about •... -
Page 3: Safety
Important Safety Instructions DANGER IMPORTANT SAFETY INSTRUCTIONS 1. Read all safety and operating instructions before using Exposure to extremely high noise levels may cause this product. permanent hearing loss. Individuals vary considerably 2. All safety and operating instructions should be kept for to noise-induced hearing loss but most will lose some future reference. -
Page 4: Table Of Contents
• Ensure the HA1000’s power is turned off. • Plug sources such as microphones, instruments, or CD/MP3 • Place the HA1000 on the floor, a table, or a sturdy stand. players into the front panel jacks. • Turn down all Level, Monitor Level, and Main Level Controls. -
Page 5: Front And Rear Panel Diagram
Front And Rear Panel Diagrams 26 18 PEAK PEAK 00-09 Vocal 00-09 Vocal 10-19 Small Room 10-19 Small Room HA1000 HIGH HIGH HIGH 20-29 Large Hall 20-29 Large Hall 12KHz 12KHz 12KHz 12KHz 30-39 Echo 30-39 Echo 14 CHANNEL • DSP • 2 X 500 WATTS... -
Page 6: Front Panel Connections
PEAK PEAK HIGH 80Hz 12KHz HIGH HIGH 12KHz HIGH 80Hz HIGH 12KHz 80Hz 12KHz 12KHz 2.5KHz 2.5KHz FX/AUX 2.5KHz POST 2.5KHz 2.5KHz FX/AUX POST FX/AUX POST 80Hz 80Hz 80Hz 80Hz 80Hz LEVEL Owner’s Manual for the HA1000 Powered Mixer LEVEL... -
Page 7: Front Panel Controls
FOOTSWITCH FOOTSWITCH FOOTSWITCH FOOTSWITCH FOOTSWITCH FOOTSWITCH FOOTSWITCH FOOTSWITCH Front Panel Controls MONITOR OUT MAIN OUT L MAIN OUT R MONITOR OUT MAIN OUT L MAIN OUT R MONITOR OUT MAIN OUT L MAIN OUT R MONITOR OUT MONITOR OUT MAIN OUT L MAIN OUT L MAIN OUT R MAIN OUT R... -
Page 8: Footswitch
MAIN L MAIN R 12KHz Phantom On/Off LEVEL FOOTSWITCH MAIN L + R MONITOR This button is used when condenser microphones are connected to the HA1000, providing This This This This BRIDGE BRIDGE PROGRAM 12V to the XLR microphone inputs. Phantom power only applies to XLR input connections. -
Page 9: Footswitch
Line Output. FX AUX to MON FX/AUX Power On/Off POST POWER FX AUX This switch turns the HA1000 on and off. When the HA1000 is powered on, the blue This This This This to MON Power LED will light. LEVEL... -
Page 10: Rear Panel Connections
CLASS 2 WIRING BRIDGE OUTPUT Bridge Output (Mono) Connect one (1) 8Ω speaker to this output. Note that damage may occur to the HA1000 if using Bridge Mode with more than one 8Ω speaker. BRIDGE MODE 1000W@ 8 OHM (8 OHM MIN. LOAD) -
Page 11: Specifications
Specifications Power Amplifier (Output): (2x) 500 Watts Input Channels Microphone Inputs Electronically balanced, discrete input Frequency Response 20Hz to 20kHz, ±3dB Gain 50dB Line Inputs Electronically balanced Frequency Response 20Hz to 20kHz, ± 3dB Gain 20dB Impedance Microphone Input 1.5kΩ All Other Inputs 10kΩ... -
Page 12: Block Diagram
Owner’s Manual for the HA1000 Powered Mixer... -
Page 13: Warranty
Harbinger. This two (2) year warranty does not reproducing any program or data stored in equipment that is used with Harbinger products.
Need help?
Do you have a question about the HA1000 and is the answer not in the manual?
Questions and answers