Caring For The Filters - Kenmore 790.8032 Use & Care Manual

Microwave hood combination
Hide thumbs Also See for 790.8032:
Table of Contents

Advertisement

CARING FOR THE FILTERS

NOTE:
Models are shipped for recirculating exhaust (To duct air outside reference the Installation Instructions
book included with your microwave.). Some models have a disposable charcoal filter installed to help remove
smoke and odors. Replacement
1.
Unplug microwave oven or disconnect power.
2. T
side. P
side
3.
detergent. Scrub and swish to remove
embedded dirt and grease. Rinse well and
shake to dry
ammonia, corrosive cleaning agents, such
as lye-based oven cleaners, or place them
in a dishwasher. The filters will turn black or
become damaged.
4. T
slot on one side of the opening. P
upward and push to the other side to lock
into place.
5. Plug in microwave oven or reconnect power.
NOTE: Do not operate the hood without the
s
are
available from Sears by calling 1-800-4-MY-HOME. The charcoal filter
ry 6 to 12 months.
s
t.
s
e.
h.
1. Unplug microwave oven or disconnect power.
2. Open the microwave door and remove the two
vent mounting screws located on top of the microwave
using a # # 1 # Phillips screwdriver.
3. Slide the vent left and tip forward. Lift out to
remove.
4.
straight out.
5.
should rest like the picture shown below.
6. Reinstall the vent by sliding the bottom of the
vent into place. Push the vent top into position
and slide right into place. Replace the two vent
mounting
screws located on top of the microwave #
1 Phillips screwdriver.#
using a #
7. Close the microwave door. Plug in microwave
oven or reconnect power.
EN-26
r
e
#

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents