Filter Installation - HABIT DT7 Instructions For Use Manual

8. Place a glass under the dispenser, push the lever back and drain the water.
9. Repeat this process several times.

Filter installation

1. Remove the filter from its wrapping.
2. Immerse the filter into cold water and agitate gently to remove any air bubbles. Note: There is no need
to pre-soak this filter before use.
3. Remove the lid and install the filter into the water tank as shown. When correctly fitted, the filter should
retain in place when the tank is turned upside-down.
4. Align the wing of filter with the retaining flange of interface of upper water tank. Screw it clockwise with
pressure until it is fitted firmly as shown.
5. The filter assembled condition as shown in the photo.
6. Hold the upper tank over a sink, and fill with cold tap water up to " Max fill level" And allow filtering
through. Flush the filter and discard the first two fillings. Place the upper tank back into the unit as
shown.
There is a minimum fill level mark printed on the water tank, which means when in daily use, you shall fill
water to the minimum level otherwise, no water comes out from the faucet. Please refer to the below photo.
When the filter icon on the filter life-span monitors flashes after 60 days, it means to replace the filter. The
used filter may be disposed as household waste.
12