HABIT DT7 Instructions For Use Manual page 12

Table of Contents

Advertisement

Available languages

Available languages

b. Aqua Optima double life water filter
c. Water filter registration card
3. Wash the lid, upper and filtered water tanks in warm soapy water, rinse and dry thoroughly.
Reassemble the tanks as shown opposite.
4. Position the chiller on a stable flat surface, close to a main power socket, not in direct sunlight and out
of reach of children.
5. Make sure that there is a gap at least 5 cm between the ventilation slots on the rear of the chiller and
any wall or surface.
6. Do not plug the unit in or install the filter yet.
7.Remove the lid and pour at least 2.5 liters of cleaned water into the tank. While pouring the water, place
a glass under the dispenser and push the lever back to drain the water.
Note: Keeping the lever open allows the air in the internal tank to be replaced with water. This
means that when the unit is first used water will flow and no air blocks can develop. It may take
some time for the water to flow through.
11

Advertisement

Table of Contents
loading

Table of Contents