Using Homelink; Security; Troubleshooting Tips - Dodge Challenger 2012 Owner's Manual

Reprogramming A Single HomeLink Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the EVIC displays "CHANNEL # TRAINING" Do not
release the button.
3. Without releasing
"Canadian/Gate Operator Programming" Step 2 and
follow all remaining steps.

Using HomeLink

To operate, press and release the programmed
HomeLink button. Activation will now occur for the
programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.
the button proceed
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 161

Security

It is advised to erase all channels before you sell or turn
in your vehicle.
To erase the channels press and hold the two outside
HomeLink buttons (I and III) for up 20 seconds. The
Electronic Vehicle Information Center (EVIC) will display
"CLEARING CHANNELS". Release the buttons when
the EVIC displays "CHANNELS CLEARED".
with
The HomeLink Universal Transceiver is disabled when
the Vehicle Security Alarm is active.

Troubleshooting Tips

If you are having trouble programming HomeLink , here
are some of the most common solutions:
• Replace the battery in the original hand-held transmit-
ter.
• Press the LEARN button on the Garage Door Opener
to complete the training for a Rolling Code.
3