Listening To An External Audio Source - LENCO IPD-4600 User Manual

Auto-Preset
1. Press the MEM
release the button.The unit starts auto-searching frequency of radio station.
2. Each time a strong radio station signal is received, it automatically memorizes the
radio stations frequency Channel 01 to 20.
Note: Number of Channel may be stored less than 20 which after the unit scanned
the frequencry band once.
3 . To exit auto-search mode, press the MEM button.
Recalling Preset Station
1. Press the button on main unit or press STANDBY
to turn on the unit.
2. To select FM radio mode, press the FUNC button on main unit (or the RADIO
button on remote cotrol) repeatedly until the radio indicator "FM" is shown on the
LCD display.
3. To select desired preset station, press the CH +/- button.
Different radio broadcast region/country
In case the unit is moved to different country/region with slightly different radio broadcast
system, the unit allows you to select Europe, Japan, Australia or USA system.
1. When the unit is in power off mode, press the remote control SET
repeatedly until the display shows the blinking "EUR"(Europe), "JAP"(Japan), "AUS"
(Australia) or "USA" AREA indicator.
2. Press the Up
broadcasting system.
Country / Region
Europe (EUR)
Japan (JAP)
Australia (AUS)
USA (USA)
3. To save the settings and exit the setting mode, wait for few seconds or press the SET
button from the remote control.
1. Connect an audio cable with 3.5mm stereo plug from an auxiliary audio device to the
AUX/LINE IN jack of the unit.
2. Press the button on main unit or press STANDBY
turn on the unit.
button until the frequency digits on display begins to scan then
/ Down button from the remote control to select one of the
FM 87.5 - 108 MHz, 0.05MHz tuning step
FM 76.0 - 90 MHz, 0.1MHz tuning step
FM 87.5 - 108 MHz, 0.05MHz tuning step
FM 87.5 - 108 MHz, 0.10MHz tuning step

Listening to an External Audio Source

button on remote control
Frequency Range
button on remote control to
11
button