JVC KD-DV6404 Instructions Manual page 87

ENGLISH
ELECTRICAL CONNECTIONS
A
Typical connections /
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
VIDEO OUT
(see diagram /
Antenna terminal
DIGITAL OUT
(see diagram
Line out (see diagram
White with black stripe White
Left speaker (front)
B
Connecting the parking brake wire /
When installing the monitor in a location where it can be seen by the driver
Connect the parking brake wire to the parking brake system built in the car.
Parking brake
When installing the monitor in a location where it cannot be seen by the driver
Connect the parking brake wire to metallic body or chassis of the car.
C
Connecting the crimp connector /
Wire connecting the battery and the parking brake switch.
Attach the parking brake wire to this point.
* 1 Not supplied for this unit.
*
2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power
cannot be turned on.
LINE IN
) (see diagram
15 A fuse
15 A
/
)
Black
Yellow *
* 2
)
Red
Blue
Blue with white stripe
Light green
Gray with black stripe
Parking brake switch (inside the car)
1
2
3
/ )
Rear ground terminal
To external components (see diagram )
To metallic body or chassis of the car
2
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
Gray Green with black stripe
Right speaker (front)
Contact the metallic part of the crimp to the wires inside.
*
1
* 2
3
12 V
250 mA
To the remote lead of other equipment (200 mA max.)
To parking brake, metallic body or chassis of the car
Green Purple with black stripe
Left speaker (rear)
Parking brake wire (light green)
To metallic body or chassis of the car
Parking brake wire (light green)
Ignition switch
Fuse block
200 mA
Purple
Right speaker (rear)
Pinch the crimp firmly.