Functions Of The Control Panel - Daewoo DWF-900S Service Manual

3. FUNCTIONS OF THE CONTROL PANEL

Control panel has micom sensor.
As the buttons are pressed, the lamps indicating the selection of your desired washing program will light up.
4 CONTROL PANEL
• Press this button to turn the power 'ON' or 'OFF'.
• It can be used to choose water temperature to be suppliued.
• As the button is pressed, water temperature will be repeated.
COLD → COLD+HOT → HOT
• In case of the single valve model, there is no wash temperature selector
function.
• It can be used to adjust amount of water according to the size of the load
to be washed.
• As the button is pressed, water level is selected by
MID → HIGH → SMALL → LOW
• It can be used to pre-engage time for wash.
• It is the button for the partial process or the combination of each process
(wash, rinse, spin) (See page 10)
• If you want to change wash time, rinse time, spin time , you must press
this button after selecing each process by the process button.
Also, this button can be used to spin only. (See page 10)
• It can be used to select the full-automatic program.
• As the button is prassed, program will be selected by following order:
FUZZY → FUZZY+DELICATE → ECO. → ECO.+DELICATE →
BLANKET → BABY CARE → SPORTS WEAR
• Operation and temporary stop is repeated as it is pressed.
• When you want change program in operating;
press the " START/HOLD" button → select the program that you want to
change → press the "START/HOLD" button again.