Baby Trend 7548 Instruction Manual page 6

SEATBACK POSITIONING
1. The front seat has a two position recline. To recline the seat, rotate the
recline bar and press backward on the seat back. Please see figure 13. To
place the seat in the upright position, press upward on the seat back while
rotating the recline bar.
2. The upright position should be used only for a child that is at least 6
months old. Note: Seat does not fully recline.
3. To recline the rear seat locate the plastic adjuster and squeeze the ends.
Loosen or tighten the strap to your desired recline position. Please see
figure 14.
TO REMOVE REAR SEAT
1. Remove the rear canopy. Locate the rear seat attachment positions.
Please see figure 15. Unhook the fabric from the tabs on the stroller
handle frame. Repeat for opposite side. Also un snap the footrest fabric
as shown in figure 15A. To completely remove rear seat fabric you
must unhook the D-Ring from the rear jump seat, and you must remove
the 2 D-Rings from the rear seat. Please See Figures 15B and 15C.
2. To remove the lower portion of the rear seat fabric, locate the two
attachment positions. Please See Figure 16. Unhook the fabric from
the tab on the lower frame tube, next release the front snap located on
the same lower frame tube.
3. When you are not using the jump seat harness place it in the storage
location on the rear of the front seat. Please See Figure 16A.
Fig.16.
Fig.16A.
TO RECLINE SEATS
Fig.15.C
Fig. 13.
Fig.14.
Fig.15.
Fig.15.A
Fig.15.B
6
6