Download Print this page

Baby Trend 7548 Instruction Manual page 5

With car seat snap n go attachment system

Advertisement

WARNING:
falling or sliding out. Always use the seat belt.
TO SECURE FRONT/REAR SITTING CHILDREN
1 The shoulder straps of the 5-point harness has 2 attachment positions.
Select the loop position that places the shoulder strap level with, or below
the top of the childʼs shoulder and feed the shoulder harness under the
correct loop. Please see figure 10.
2. Carefully place the child in the stroller seat and bring the safety harness
around the childʼs waist and over the shoulders. Place the crotch strap
and between the childʼs legs. Insert the male end of each shoulder / waist
belt into the buckle on the crotch strap. Tighten the harness to be snug
around the childʼs waist and over the childʼs shoulders. Please see figure
11.
3. To release, apply pressure to both sides of each male clip until the clip
is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child. NOTE: Buckles may be hard
to release when 1st used.
TO SECURE REAR STANDING CHILD
1. The rear platform and jump seat are designed to accommodate a child
who is at least 2 1/2 years old, has good balance and coordination, and is
not over 40 inches tall. Position the child on the platform on the back of
the stroller. Be sure child is facing forward and hands are holding frame.
Secure the safety belt behind child and engage buckle. See figure 12.
2. Be sure that the childʼs feet are fully on the platform at all times.
PLEASE NOTE: When using the rear SEAT you must put the STAND
FEATURE SAFETY BELT in the storage location located on the rear of
the seat. Please See Fig. 12A
WARNING:
choking hazzard when using the rear seat, put
the STAND FEATURE SAFETY BELT in the
storage location on the rear of the seat.
1. Have child sit on the jump seat facing backwards. Secure the seat belt,
which is attached to the back of the seat, around the childʼs waist, and
buckle to the crotch strap. See figure 12B. Adjust the seat belt to be snug
around the childʼs waist.
2. To release, apply pressure to both sides of the male clip until the clip
is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child.
3. Be sure that the childʼs feet are fully on the platform at all times.
Avoid serious injury from
TO SECURE CHILD
To avoid a possible
TO USE JUMP SEAT
Waist
Strap
Crotch Strap
I
Fig. 10.
Shoulder Strap
Squeeze
Adjust for a
snug fit
Fig. 11.
Fig. 12.
Fig. 12A.
Fig. 12B.
5

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Sit n stand plus 7548