Receiver Hitch & Draw Bar (If Equipped) - Motor Trike GLADIATOR Owner's Manual

RECEIVER HITCH & DRAW BAR (IF EQUIPPED)
Proper installation of the draw bar into the receiver hitch is critical for your safety while towing a
trailer. There is a bolt located on the bottom of the draw bar receiver tube that eliminates the draw bar
from rattling. Use a 9/16" wrench when adjusting this bolt. It is necessary to remove this bolt in order to
remove the draw bar. Warning, this bolt is not intended to retain the drawbar when towing a trailer. The
draw bar pin and safety pin must be installed. Refer to Figure 5 and Figure 6 below.
In order to properly install the draw bar:

Loosen the bolt located on the bottom of the receiver tube.

Slide the draw bar into the receiver tube.

Insert the draw bar pin through the receiver tube and the hole in the draw bar.

Clip the safety pin into the groove put into the draw bar pin.

Tighten the bolt supplied under the receiver tube against the draw bar to prevent it from rattling.
Revision 2
DRAW BAR
DRAW BAR PIN
Figure 5: Draw Bar Components
SAFETY PIN
Page 8 of 14