Other Problems - Epson EB-X92 User Manual

Problem Solving

Other problems

No sound can be heard or the sound is faint
Check
Is the audio source connected correctly?
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
The Remote Control does not work
Check
Is the Remote Control light-emitting area pointing towards the
Remote Receiver on the projector when it is operated?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the Remote Receiver?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s
I want to change the language for messages and menus
Check
Change the Language setting.
Disconnect the cable from the Audio port, and then reconnect the cable.
Adjust the volume so that sound can be heard. s
Press the [A/V Mute] button on the Remote Control to cancel A/V Mute. s
When using a commercially available audio cable, make sure it is labeled "No resistance".
Point the remote control towards the Remote Receiver.
Operating range s Quick Start Guide
The operating range for the remote control is about 6 m. s Quick Start Guide
Set the projector up in a location where strong light does not shine onto the Remote Receiver.
Adjust the "Language" setting from the Configuration Menu. s
Remedy
p.52 s Quick Start Guide
p.25
Remedy
Remedy
p.53
69
p.74