Handlebar Adjustments - Polaris 600 IQ Widetrak Owner's Manual

THE PERFECT FIT

Handlebar Adjustments

Use the following steps to adjust handlebar angle at the handlebar block.
1. Remove the mountain bar.
2. Remove the handlebar cover.
3. Using a 7/16" wrench, loosen
the four nuts on the bottom of
the adjuster block. Turn the
handlebar to the left or right for
access to the back nuts. If nec-
essary, pry the blocks apart
with a screwdriver.
4. Adjust the handlebar to the
desired height. Be sure the han-
dlebar, brake lever and throttle
lever operate smoothly and do
not hit the gas tank, windshield
or any other part of the
machine when turned fully to
the left or right.
5. Torque the front bolts first,
then torque the rear bolts.
Torque the bolts to 15-17 ft.
lbs. (20-23 Nm).
6. Reinstall the handlebar cover.
7. Reinstall the mountain bar.
54
Mountain
Bar
Handlebar
Cover
Adjuster
Block
Bolts
Nuts