Table of Contents
Advertisement
6. Troubleshooting
If problems with the unit persist even after you've followed the suggestions below, please disconnect the power cord and
contact the retailer from whom you purchased the unit.
Description of problem
The unit is not turned on.
This unit does not work
correctly.
TEMP indicator illuminates.
FAN indicator illuminates.
7. Maintenance
The elapsed operating time, which can be a guide to know the periodic maintenance timing, is available in the <Elapsed
Operating Time> menu (System Menu
manual of the recorder. The indication of the operating time of the recorder may vary from the actual operating time. It is
recommended to use this indication just for your reference.
When this unit is registered as a Copy 1 device, check the indication of Copy 1, SerialBus.
When this unit is registered as a Copy 2 device, check the indication of Copy 2, SerialBus.
When this unit is registered as a Main device, the elapsed operating time of this unit is not displayed. (The elapsed
operating time of the recorder connected with this unit is displayed.)
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Please consult the following
• Is the power cord properly plugged in?
• Is the EXTERNAL CONTROL switch set to ON though the DC 12 V OUT
terminal of the recorder and the CONT IN terminal of this unit are not
connected ?
• Is the USB cable connected correctly?
• Are the menus set correctly in the recorder?
• Are the recording devices connected exceeding the specified connectable
number?
• Turn off the power. Turn on the power again after the internal temperature
drops.
• Replace the fan with new one. Ask your dealer to replace the fan.
Service Info
Elapsed Operating Time) of the recorder. Refer to the installer's
13
Advertisement
Table of Contents
