from computer 5 (page12) Quiet Design -- does the sound of the compressor starting many minute second minute second random to help avoid power surges -- This protection feature will a ensure indoor emperature does not fall below freezing When your PTAC (which is can be switched off (please see page 9) feature off (see section...
Amperage and voltage of the PTAC and branch circuit must match according to local cord.
When units are shipped with a sleeve: We recommend always to use a Frigidaire sleeve. When units are shipped without a sleeve: Your product that s ps the inside air on side...
Frigidaire RIGIDAIRE RIGIDAIRE GRILLE (see Frigidaire , the actual baffle kit m look image...
ATION OF A FRIGIDAIRE PTAC INTO A FRIGIDAIRE WALL SLEEVE...
screw FOR DUCTED INSTALLATIONS ONLY NOTE: Upward air direction should only be used on ducted installations.
/Energy Saver: Cooling /Energy Saver: Heating The dip adjust accordingly in order to allow the wall t control of the unit. When in wall mode, the control panel will be disabled. 3*4.Energy Saver ip Switches /Energy Saver This is the most efficient mode for electrical usage. 5*6.
SYSTEM CONFIGURATION KEYPAD CONFIGURATION Keypad Configuration You can customize your unit additionally using the keypad configuration options. To enter Keypad configuration Connect the unit to power. Press and hold the "fan speed " and the "V " for 5 continuous seconds, within 30 seconds of the unit being powered up.
control panel guard Low fan Hi fan on page 17...
Frigidaire they error Table 5—STATUS LED Indicator Definitions Indoor air temp sensor open/short 8-segment display ‘F1’, with STATUS light flash 1 times and off 3 sec, repeat 8-segment display ‘F2’, with STATUS light flash 2 times and off 3 sec, repeat...
unit. "ON-OFF" "mode" " " "V" 5. "fan speed" It is used for setting high, medium, low or auto fan speed. The corresponding LED will be lit when selected. 6. "timer" It is used for setting timer function.
OPERATION 7. Timer function (1) Timer ON: When the unit is off, timer ON can be set. Setting range is 0.5~24h. When timer ON time is reached, the system will operate according to the set mode. (2) Timer OFF: When the unit is off, timer OFF can be set. Setting range is 0.5~24h. When timer OFF time is reached, the system will stop operation.
from its sleeve inspect dirt Product failure due to improper care or lack of maintenance is not covered by warranty Product failure due to improper care or lack of maintenance is not covered by warranty days (or sooner depending on application).
2. Do not place containers containing water on unit. 3. Turn off the air conditioner at the power source when it will not be used for an extended period of time. 4. Periodically check the condition of the unit’s installation base for any damage.
MAJOR APPLIANCE WARRANTY Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.