HIGH PASS
HIGH PASS
2. The Red Switch is the input voltage setting; select the appropriate 120V or 230V setting.
3. Connect the detachable IEC Power Cord underneath the Red Voltage Selection Switch.
AUDIO OUTPUTS
_ - - - - AUDIO OUTPUTS - - - - _
@€)@€)
I
I
I
I
~SUB1-=
=-SUB2-@
1. Connect the speaker wires to the Binding Posts. NOTE: Red is Positive and Black is
Negative.
2. Use either Bare Speaker Wire or Banana Plugs to terminate the speaker wire.
AUDIO INPUTS
AUDIO OUTPUTS . - AUDIO INPUTS
oro
BA~NCED
50?O
1. Connect to either the Balanced Female XLR or Unbalanced Female RCA Inputs.
NOTE: Both inputs have been calibrated to the same sensitivity level.
AUDIO OUTPUTS
AUDIO OUTPUTS . - AUDIO INPUTS
orOh
50?O~
1. Connect to the Unbalanced Female RCA Outputs.
2. Set the High Pass Crossover to the desired frequency. The slope is set at 12 dB/octave.
9