Ariston RCC300-SM Installation Manual page 7

RCC 300 SUBWOOFER AMPLIFIER (RCC300-SA)
The RCC 300 Subwoofer Amplifier can be installed into either cabinetry, on an equipment shelf, or
it can be rack-mounted into a standard 19" Equipment Rack. In any installation be sure to
provide adequate ventilation around the amplifier.
The RCC300-SA has two simple and conveniently placed mode settings. The Music or Movie
user controls are located on the front panel for selection based on the source material. The Mode
settings, Volume and Power Controls of the RCC300-SA can be accessed via IR codes. The
remote included with your unit can be downloaded into a learning remote or HEX Codes are
available on the Artison Web site. The Front Panel of the RCC300-SA has an IR Receiver and
there is a second hard wired feed thru jack that can be connected to an integrated control system
on the rear panel. Each control is described in detail below.
RACK-MOUNT INSTALLATION OF THE RCC300-SA
1. Remove the amplifier's four feet from the bottom of the chassis.
2. Attach the included rack-mount ears to the front sides of the RCC300-SA.
3. Mount into the 19" equipment rack, the amplifier will occupy 1.5 RU. Using the supplied
~
RU Blank Spacer either above or below the amplifier will occupy 2 RU.
4. If installing two RCC300-SA then the rack-mount ears can be flipped to accommodate
t~e
two
amplifiers in 3 RU.
RCC300-SA REMOTE CONTROL
The remote control has the following functions:
1. ON/OFF - This will toggle between Standby Mode (Amber Halo) and ON (Blue Halo).
2. MUSIC - This selects the MUSIC EO. When active it will have a Red Halo added to the Blue
Halo.
3. MOVIE - This selects the MUSIC EO. When active it will have a Red Halo added to the Blue
Halo.
4. GAIN - This will raise and lower the volume of the amplifier. A remote or the volume controls
on the front panel can both be used to raise or lower the volume. NOTE: The gain control is
configured so that the "last used" device setting will be remembered by the amplifier.
7