Storage; Moving About; Disassembling The Scooter For - Mercury Regatta Owner's Handbook Manual

6.3 Fuses
Battery charger fuse. If the battery charger is switched on and no LEDs are lit, check the fuse.
6.4 Tyres
The condition of the tyres depends on how you drive and use the scooter. Please check the tyre tread
depth regularly. Replace the tyres when there is less than 0.5mm tread on the tyres.
Attention
• When tread depth is less than 0.5mm it can easily lead to the vehicle slipping and
braking distances will become longer. Therefore, replace any tyres with low tread
depth as soon as possible.
• The tyre pressure should be kept at around 26psi (1.8bar) for the best ride and
handling.
Suggestion
• Ensure water is not directly splashed on to your scooter as this can cause damage to
the electrics. Do not use petrol, solvents or vaporizing solution as these may deform
or damage the shrouds.
• Do not use wax.

6.5 Storage

Ensure the vehicle is stored with the seat set in the 'forward' position and switched off at the ignition.
Store the scooter in an environment away from direct sunlight or damp. When storing for long periods
of time, charge the battery fully and then disconnect the battery terminal.

6.6 Moving About

• Switch the scooter off at the ignition before moving.
• Lift the scooter by the chassis (not the bumpers). Lifting the scooter by the bumpers could cause
damage or injury.
• For your safety, always ask for help if required. You will need 2 or 3 people when moving or
lifting the vehicle. To reduce the weight of the vehicle, remove the seat and batteries if required.
6.7 Disassembling the Scooter
The scooter can be disassembled for ease of transportation or storage. For information on how to do
this, please contact your Medicare Technology dealer.
Mercury Regatta
Owner's Handbook
Part code: Z40960 (Rev A)
Page 16 of 20