Indicator Switch; Horn Button - Mercury Regatta Owner's Handbook Manual

Table of Contents

Advertisement

If the battery gauge flashes but the scooter will still drive, then this indicates low battery
power and the batteries should be recharged immediately. If the battery gauge flashes and
the scooter will not drive, this indicates that a fault has been detected with the scooter. In
this case seek advise from your dealer.
Suggestion
1. You should recharge the batteries each time the vehicle is used to ensure maximum range
and optimal battery performance. If the scooter is stood idle, the batteries should still be
charged once a week to maintain battery performance.
2. After charging or replacing a new battery, drive the vehicle for 2 to 3 minutes to ensure the
battery capacity is sufficient. Then charge the battery immediately if not recently charged.
3. In wintertime, the battery may respond more slowly and battery range may be reduced.
Cold temperatures temporarily reduce battery performance.
4. When driving on a gradient, the battery gauge reading might fluctuate. This is a normal
phenomenon and there is no cause for concern.
5. Even if a battery is used properly, it is natural for the battery's capacity to reduce with
time, which results in reduced battery range. The batteries should be replaced when you
find that battery range is about only half of the range of when the batteries were
performing optimally. Please see your dealer about replacement batteries and the safe
disposal of your old batteries. If you continue to use the batteries, it is likely you will see a
rapid decline in performance.
6. The battery range is reduced when driving frequently up gradients or on rough terrain, as
this causes greater power consumption.
• Speed Dial
• The speed dial determines the maximum speed of the scooter. Turn the dial clockwise to
increase the maximum speed, or turn anticlockwise to decrease the maximum speed.

• Indicator switch

• This switch flashes the right hand side or left hand side indicators intermittently.
To use the indicators, push the switch in the required direction of travel (i.e. left or right)
and release the switch. To switch the indicators off, push the switch in and release.
• Hazard Warning Light Switch
• Press and release the switch to operate the hazard warning lights. Press the switch again to
stop the hazard warning lights flashing.

• Horn Button

• Press the Horn button to sound the horn. Release the button to stop the horn from
sounding.
Mercury Regatta
Owner's Handbook
Part code: Z40960 (Rev A)
Page 10 of 20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents