Philips Streamium MCi500H Quick Start Manual page 15

Only use attachments/accessories specified by the
k
manufacturer.
Use only with the cart, stand, tripod, bracket, or
l
table specified by the manufacturer or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury
from tip-over.
Unplug this apparatus during lightning storms or when
m
unused for long periods of time.
Refer all servicing to qualified service personnel.
n
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
Battery usage CAUTION – To prevent battery leakage
o
which may result in bodily injury, property damage, or
damage to the unit:
• Install all batteries correctly, + and - as marked on
the unit.
• Do not mix batteries (old and new or carbon and
alkaline, etc.).
• Remove batteries when the unit is not used for a
long time.
Apparatus shall not be exposed to dripping or
p
splashing.
Do not place any sources of danger on the apparatus
q
(e.g. liquid filled objects, lighted candles).
This product may contain lead and mercury.
r
Disposal of these materials may be regulated due
to environmental considerations. For disposal or
recycling information, please contact your local
authorities or the Electronic Industries Alliance: www.
eiae.org.
Warning
•
Never remove the casing of this MCi500H.
•
Never lubricate any part of this MCi500H.
•
Place this MCi500H on a flat, hard and stable surface.
•
Never place this MCi500H on other electrical equipment.
•
Only use this MCi500H indoors. Keep this MCi500H away
from water, moisture and liquid-filled objects.
•
Keep this MCi500H away from direct sunlight, naked flames
or heat.
How to connect a plug
The wires in the mains lead are coloured with the
following code: blue = neutral (N), brown = live (L).
As these colours may not correspond with the
colour markings identifying the terminals in your
plug, proceed as follows:
• Connect the blue wire to the terminal marked
N or coloured black.
• Connect the brown wire to the terminal
marked L or coloured red.
• Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath of
the lead - not simply over the two wires.
Mains plug
This apparatus is fitted with an approved 13 Amp
plug. To change a fuse in this type of plug proceed
as follows:
a Remove fuse cover and fuse.
Fix new fuse which should be a BS13625 Amp,
b
A.S.T.A. or BSI approved type.
Refit the fuse cover.
c
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should have
a value of 5 Amp. If a plug without a fuse is used,
the fuse at the distribution board should not be
greater than 5 Amp.
The severed plug must be disposed off to avoid a
possible shock hazard should it be inserted into a
13 Amp socket elsewhere.
norge
Typeskilt finnes på apparatens bakside.
Observer: Nettbryteren er sekundert innkoplet.
Den innebygde netdelen er derfor ikke
fraktoplet nettet så lenge apparatet er tilsluttet
nettkontakten.
For å redusere faren for brann eller elektrisk støt,
skal apparatet, ikke utsettes for regn eller fuktighet.
Notice
notice of compliance
For USA:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed