Condensate Evaporation - Soleus Air PE8-11R-32 Operating Instructions Manual

Btu portable air conditioner with evaporative technology
Table of Contents

Advertisement

CONDENSATE EVAPORATION

Emergency Condensate Holding Tank
When the room temperature is low and the indoor humidity is high, the air conditioner may not be able to
evaporate some of the moisture fast enough. When this happens, the water will accumulate in an emergency
condensate tank inside the unit. Once the emergency condensate tank is full, the unit will automatically shut
off and the led of BUCKET FULL will light up on the control panel display. To empty the condensate tank,
pull the drain plug at the bottom back of the unit. You will need a small pan, approximately 1" high to catch
the water coming out of the condensate tank. Connect the supplied drainage hose to the back of the unit to
aid in drainage into the pan. Once the condensate tank is drained, the unit will begin working within a few
minutes. The emergency condensate tank is approximately 1.5 Liters of water. Another option is to purchase
a small hose from a hardware store that can fit around the 5/8" drain plug on the back of the unit and drain
the unit into a gravity drain or larger pan for continuous drainage. It is not advised to use continuous drain-
°
age when the room temperature is higher than 90
F .
If you do not need the emergency tank emptied immediately simply leave the unit on. The fan in your air
conditioner will continue to run to help evaporate the moisture as fast as possible. This will usually take
around 60 minutes depending on how much water is in the tank.
To resume operation quickly, empty the water container according to the following steps:
1. Turn the unit off. Do not move the unit when the water container is full.
2. Place the drain pan accessory under the drainage port at the back of the unit.
3. Remove the rubber plug from the drain hole. The condensate water will drain out automatically.
4. When the drain pan is full, install the rubber plug back onto the drainage hole to stop the water flow.
5. Empty the drain pan.
6. Repeat steps 2-5 until all the water is emptied.
NOTE: Once the water container has been emptied, install the rubber plug back onto the drain hole. It is not
°
advised to use continuous drainage when the room temperature is higher than 90
F .
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pe8-12r-32Ky5-110

Table of Contents