Vetter Floating Mount Saddle Bags Owner's Manual And Mounting Instructions page 17

140 130 076
oVetter Corp. 1979
4-27-79
Supplement
1979
Honda 750F
6
Remove turn signals
Disconnect the turn
signal wires. Remove
the Phillips head screw
securing the stalk to
the tab. Thread the
wiring through the tail
section and remove the
turn signal assembly.
2
Mount side loop
at grab bar mount
While holding the side
loop in place, slide
the stock bolt through
the side loop mounting
bracket and into the
grab bar mount.
7
Mount luggage rack
strut
Position the rear
luggage strut, insert
the turn signal mounting
tab through the strut,
tomahawk, flat washer
and into the 12mm lock
nut.
Attach the turn signal
to the mounting tab
with the original Phillips
head screw. Reroute the
wires and connect them
at their designated bullet
connectors.
Floating Mount
Saddle Bags
Owner's Manual and Mounting Instructions
NOTE: The 1979 Honda CB750F factory-supplied exhaust is not compatible with the
Floating Mount Saddle Bag system and must be replaced with a suitable substitul
Your dealer can probably suggest an exhaust system which is compatible.
LOCK NUT
FLAT WASHER
TOMAHAWK
TURN SIGNAL TAB